Terminal Assignment Of The Control Modes - Lenze 8400 StateLine C Reference Manual

7.2.3

Terminal assignment of the control modes

The following comparison provides information about which inputs/outputs of the application block LA_NCtrl are interconnected
to the digital and analog input/output terminals of the drive controller in the different control modes.
10: Terminals 0 12:
Digital input terminals
X4/RFR
X4/DI1 Fixed setpoint 1/3
bJogSpeed1
X4/DI2 Fixed setpoint 2/3
bJogSpeed2
X4/DI3 Activate manual DC- Quick stop
injection braking (DCB) bSetQuickstop
bSetDCBrake
X4/DI4 Change of direction of rotation
bSetSpeedCcw
Analog input terminals
X3/A1U, A1I
10 V ≡ 100 % reference speed (C00011)
Digital output terminals
X4/DO1
X101/COM, NO
Analog output terminal
X3/O1U
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Terminals 2 14: Terminals 11 16: Terminal 16
Controller enable / Reset of error message
Change of direction of Fixed setpoint 1/3
rotation bJogSpeed1
bSetSpeedCcw
Activate manual DC- Fixed setpoint 2/3
injection braking (DCB) bJogSpeed2
bSetDCBrake
Motor potentiometer: CW rotation quick stop
Increase speed bRLQCw
bMPotUp
Motor potentiometer: CCW rotation quick stop
Decrease speed bRLQCcw
bMPotDown
Main speed setpoint
nMainSetValue_a
10 V ≡ 100 % reference speed (C00011)
Control mode (C00007)
20: Keypad 21:
bFailReset
- -
- -
- -
- -
- -
Status "Drive is ready"
bDriveReady
Status "Error is pending"
bDriveFail
Actual speed value
nMotorSpeedAct_a
PC 30: CAN 40: MCI
Quick stop
bSetQuickstop
- -
- -
- -
Additional speed setpoint
nAuxSetValue_a
10 V ≡ 100 % reference speed (C00011)