Readytoswitchon - Lenze 8400 StateLine C Reference Manual

4.2.5

ReadyToSwitchOn

LED DRIVE READY
The controller is in this device status directly after the initialisation has been completed!
 The bus systems are running and the terminals and encoders are evaluated.
 The monitoring modes are active.
 The controller can be parameterised.
 The application is basically executable.

Note!
• The "ReadyToSwitchOn" status is not only activated after the mains
connection, but also after the deactivation of "Trouble", "Fault" or
"SafeTorqueOff".
• If
explicit deactivation of the controller inhibit after mains connection is always
required for the controller to change from the "ReadyToSwitchOn" status to
the "SwitchedOn" status.
• If only the 24V voltage supply is available during the mains connection, the
error message
the drive controller and the drive controller remains in the
"ReadyToSwitchOn" status.

Danger!
If the "Inhibit at power-on" auto-start option has been deactivated in
the "ReadyToSwitchOn" status switches directly to the SwitchedOn" status after
mains connection.
Automatic restart after mains connection/fault...
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
LED DRIVE ERROR
OFF
C00142 activates the autostart option "Inhibit at power-on" (Lenze setting),
"LU: Undervoltage in the DC
L
8400 StateLine C | Reference manual
Device state machine and device statuses
Display in C00137 Display in status word 1 (C00150)
Bit 11
ReadyToSwitchOn 0
bus" is entered into the logbook of
( 97)
Device control (DCTRL)
Bit 10 Bit 9 Bit 8
0 1 1
C00142,
91