6.2.1.1
Signal adaptation by means of characteristic
This function extension is only available from version 04.00.00!
An individual characteristic according to the illustration below can be parameterised for
the analog input via the subcodes of
In this case the input signal corresponds to the X axis and the output signal corresponds to
the Y axis:
[6-4]
Characteristic for analog inputs
Parameter
C00010/1
C00010/2
C00010/3
C00010/4
C00010/5
C00010/6
C00010/7
C00010/8
In the »Engineer«, there is a parameterising dialog for entering the characteristic. This
dialog also displays the set characteristic graphically.
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
C00010
199.99 %
y
max
y
min
-x
max
-199.99 %
-199.99 %
Info
AIN1: (+y0) = min
AIN1: (+x0) = Dead band
AIN1: (-y0) = (-min)
AIN1: (-x0) = (-Dead band)
AIN1: (+ymax)
AIN1: (+xmax)
AIN1: (-ymax)
AIN1: (-xmax)
L
8400 StateLine C | Reference manual
to provide different slopes and a dead band.
199.99 %
x
max
-y
min
-y
max
I/O terminals
Analog terminals
Lenze setting
Value Unit
0.00 %
0.00 %
0.00 %
0.00 %
199.99 %
199.99 %
199.99 %
199.99 %
277