Reset Error; Delete Logbook - Lenze 8400 StateLine C Reference Manual

8400 StateLine C | Reference manual
Device control (DCTRL)
Device commands (C00002/x)
4.1.6

Reset error

The C00002/19
if the error cause has been eliminated and thus the error is not pending anymore.
 After the reset (acknowledgement) of the current error, further errors may be pending
which must also be reset.
 The status determining error is displayed in C00168.
 The current error is displayed in C00170.

Tip!
An error message can also be acknowledged by activating the Reset error button in
the Diagnostics tab.
Detailed information on error messages can be found in the
management" chapter.
4.1.7

Delete logbook

The C00002/21

Tip!
Click the Logbook button in the Diagnostics tab to display the logbook in the
»Engineer«.
In the Logbook dialog box, it is also possible to delete all logbook entries by clicking
the Delete button.
Detailed information on the logbook can be found in the
management" chapter.
84
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
= "1: On / start" device command acknowledges an existing error message
( 380)
= "1: On / start" device command deletes all logbook entries.
( 380)
L
"Diagnostics & error
"Diagnostics & error
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011