Parameters With Subcodes - Lenze 8400 StateLine C Reference Manual

8400 StateLine C | Reference manual
Introduction: Parameterising the controller
General notes on parameters
General operation
Par1 8400 StateLine C
1.
USER - Menu
Code list
Go To Param
SAVE
EDIT
EDIT
EDIT
4.
ESC
[2-2] Example: Change parameter with the keypad
Multilingualism
All texts displayed in the keypad are in English.
From version 11.00.00
configuration parameters can are also available in German and French. To set a different
language, select the Language selection menu item in the main menu of the keypad.
English
Deutsch
Français
ESC
36
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Load Lenze setting
2.
C00002/001
Off / Finished
Fixed setpoint 1
3.
C00039/001
40.00 %
Fixed setpoint 2
C00039/002
60.00 %
Fixed setpoint 2
C00039/002 5.
60.00 %
OK
6.
onwards, the most important menus as well as diagnostic and
Language
OK
L
1. Use the / navigation keys to select the
 
desired menu.
– Use the / navigation keys to reach a
 
higher/lower menu level.
– Use the function key to return to the

main menu.
2. Use the / navigation keys to select the
 
parameter to be set within a submenu.
3. In order to select another subcode in case of
a parameter with subcodes:
– Press the navigation key
he editing mode for the subcode.
– Use the navigation keys to set the
desired subcode.
4. Use the function key to switch over to

the editing mode.
5. Use the navigation keys to set the desired
value.
6. Use the function key to accept the

change and to leave the editing mode.
– Use the function key to leave the

editing mode without accepting the
change.
 The multilingual texts are stored in the
controller and do not have to be loaded into
the device.
 For reasons of disc space, only the most
important menus and parameters as well
as the error messages are available in
several languages.
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
to change tot
