Show Mac Current - Hitachi Compute Blade 500 Series User Manual

50:00:08:70:00:5b:e1:51
mezzanine
50:00:08:70:00:5b:e1:53
mezzanine
50:00:08:70:00:5b:e1:55
mezzanine
50:00:08:70:00:5b:e1:57
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
When you specify -p parameter and a non-primary server blade in SMP
configuration, the following message appears without showing WWN.
E0640 : <Blade %1$d> Command was canceled. Specified blade is not the
primary blade of SMP.

show mac current

Command
Show mac current [-b <blade_no>] [-p]
Description
Displays MAC address which the card installed on server blade is using.
In SMP configuration
When you specify the primary server blade or a non-primary server blade,
MAC address of the specified server blade is displayed.
When specifying -p parameter, specify the primary server blade with -b
parameter to show MAC address of all server blades in SMP configuration.
Not in SMP configuration
Shows MAC address of the server blade specified with -b parameter. Even
if -p parameter is specified, the result is the same.
Role
Chassis
Parameters
-b <blade_no>
Slot number of the server blade in the server chassis
2-14
2 1
2 2
2 3
Command: show mac current -b <server blade number>
Command: show mac current -b <server blade number> -p
Range is from 0 to 7.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
50:00:08:70:00:5b:e1:52
50:00:08:70:00:5b:e1:54
50:00:08:70:00:5b:e1:56