Hitachi Compute Blade 500 Series User Manual page 28

When you specify the primary server blade or a non-primary server blade,
WWN of the specified server blade is displayed.
When specifying -p parameter, specify the primary server blade with -b
parameter to show WWNs of all server blades in SMP configuration.
Not in SMP configuration
Shows WWN of the server blade specified with -b parameter. Even if -p
parameter is specified, the result is the same.
Role
Chassis
Parameters
-b <blade_no>
Slot number of the server blade in the server chassis
-p
In SMP configuration, when you specify -p parameter, WWNs of all server
blades are shown. Then, specify the primary server blade with -b
parameter. Not in SMP configuration, WWN of each server blade is shown.
Show items
-- Current WWN List--
Slot
Slot number of the server blade in the server chassis
WWN type
Type of WWN
Card
Type of card
2-10
Command: show wwn current -b <server blade number>
Command: show wwn current -b <server blade number> -p
Range is from 0 to 7.
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted, the
command shows all server blades.
Range is from 0 to 7.
default: Default Physical WWN
optional: Optional Physical WWN
Mezzanine
Onboard LAN
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide