Hitachi Compute Blade 500 Series User Manual page 166

-sd <dst_day>
Start day of daylight saving time.
-sh <hour>
Start hour of daylight saving time.
-sn <minute>
Start minute of daylight saving time.
-em <dst_month>
End month of daylight saving time.
-ed <dst_day>
End day of daylight saving time.
-eh <hour>
End hour of daylight saving time.
-en <minute>
End minute of daylight saving time.
2-148
Range is from 1 to 12.
Show by either of the following.
Numerical value : Range is from 1 to 31.
"lastDDD" : It is a DDD day of the week of the last of the month.
"DDD" is "Sun", "Mon", "Tue", "Wed", "Thu", "Fri" or "Sat".
"DDD>=Y" : It is DDD day of the beginning on and after the Yth.
"DDD" is "Sun", "Mon", "Tue", "Wed", "Thu", "Fri" or "Sat". "Y" is from
1 to 31.
"DDD<=Y" : It is DDD day of the Yth previous last. "DDD" is "Sun",
"Mon", "Tue", "Wed", "Thu", "Fri" or "Sat". "Y" is from 1 to 31.
Range is from 0 to 23.
Range is from 0 to 59.
Range is from 1 to 12.
Show by either of the following.
Numerical value : Range is from 1 to 31.
"lastDDD" : It is a DDD day of the week of the last of the month.
"DDD" is "Sun", "Mon", "Tue", "Wed", "Thu", "Fri" or "Sat".
"DDD>=Y" : It is DDD day of the beginning on and after the Yth.
"DDD" is "Sun", "Mon", "Tue", "Wed", "Thu", "Fri" or "Sat". "Y" is from
1 to 31.
"DDD<=Y" : It is DDD day of the Yth previous last. "DDD" is "Sun",
"Mon", "Tue", "Wed", "Thu", "Fri" or "Sat". "Y" is from 1 to 31.
Range is from 0 to 23.
Range is from 0 to 59.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide