Set Remote-Access Protocol Ssh - Hitachi Compute Blade 500 Series User Manual

Message
None
Example
[To display SSH connection permission settings for IPv4 and IPv6 addresses]
$ show remote-access protocol ssh
-- SSH setting --
Allow
Network address
Subnet mask
-- SSH setting (IPv6) --
Allow : allow
Network address
Prefix len
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None

set remote-access protocol ssh

Command
set remote-access protocol ssh [-a <allow>] [-n <network_addr>]
[-s <subnet_mask>] [-a6 <allow>] [-n6 <network_addr>] [-p6
<prefix_len>] [-F]
Description
Edit the setting of connection allowance of SSH.
You can change the following items:
(1) Connection permission settings for IPv4 addresses
¢
¢
(2) Connection permission settings for IPv6 addresses
¢
¢
If you omit a parameter, the corresponding settings will not be changed. If
you omit all parameters, the command will end normally without making any
changes.
: allow
: 192.168.0.0
: 255.255.255.0
: fe80::200:87ff:feb2:c24
: 64
Whether SSH connections are permitted
Range of IP addresses to be permitted (network address and subnet
mask)
Whether SSH connections are permitted
Range of IP addresses to be permitted (network address and prefix
length)
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-225