Set Remote-Access Protocol Ftp - Hitachi Compute Blade 500 Series User Manual

Message
None
Example
[To display the FTP connection permission settings for IPv4 and IPv6
addresses]
$ show remote-access protocol ftp
-- FTP setting --
Allow
Network address
Subnet mask
-- FTP setting (IPv6) --
Allow
Network address
Prefix len
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None

set remote-access protocol ftp

Command
set remote-access protocol ftp [-a <allow>] [-n <network_addr>]
[-s <subnet_mask>] [-a6 <allow>] [-n6 <network_addr>] [-p6
<prefix_len>] [-F]
Description
You can change the following items:
(1) Connection permission settings for IPv4 addresses
¢
(2) Connection permission settings for IPv6 addresses
¢
¢
If you omit a parameter, the corresponding settings will not be changed. If
you omit all parameters, the command will end normally without making any
changes.
2-210
: allow
: 192.168.0.0
: 255.255.255.0
: allow
: fe80::200:87ff:feb2:c24
: 64
Whether FTP connections are permitted
Range of IP addresses whose connection is permitted (network
address and subnet mask)
Whether FTP connections are permitted
Range of IP addresses whose connection is permitted (network
address and prefix length)
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide