Set Blade Os-Mode - Hitachi Compute Blade 500 Series User Manual

Comment
When the N+M cold standby setting is enabled, Optional Physical WWN is
applied even if it specifies the Default Physical WWN.
When you specify a non-primary server blade, the setting will not affect the
server blade operation. The following message appears to warn you.
W0031 : <Blade X> Set data is not used. Specified blade is not the primary
blade of SMP. (X: a server blade you specified)

set blade os-mode

Command
set blade os-mode [<blade_no>] -m <os_mode> [-F]
Description
Edits the OS operation mode of server blade.
In SMP configuration, when you specify the primary server blade, the OS
mode setting for all server blades is changed. When you specify a non-
primary server blade, the setting is changed but will not affect the server
blade operation.
Role
Server Blade
Parameters
<blade_no>
Slot number of server blade in the server chassis
-m <os_mode>
Logical Partitioning
-F
Executes the command without inquiry.
Show items
None
Range is from 0 to 7.
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted, the
command shows all server blades.
basic : Logical Partitioning is disabled.
hvm : Logical Partitioning is enabled.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-69