Hitachi Compute Blade 500 Series User Manual page 44

Show items
-- Blade setting --
Slot
Slot number of the server blade in the server chassis
-- Blade AC recovery setting --
AC recovery
¢
¢
¢
In SMP configuration, when you specify a non-primary server blade, the
setting value is shown in parentheses and will not affect the non-primary
server blade operation.
Wait time(min)
Waiting minutes until power recovery.
-- Blade pre-configure setting --
N+M
Ability of N+M cold standby.
WWN type
Type of WWN.
2-26
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted, the
command shows all server blades.
Range is from 0 to 7.
stay
The server blade power is keep turning off when the power is supplied
to the server chassis.
pon
The server blade power on when the power is supplied to the server
chassis.
last
Returns to the state of the server blade that in the last time when the
power is supplied to the server chassis.
In SMP configuration, when you specify a non-primary server blade,
the setting value is shown in parentheses and will not affect the non-
primary server blade operation.
enable : N+M cold standby is enabled.
disable : N+M cold standby is disabled.
In SMP configuration, when you specify a non-primary server blade,
the setting value is shown in parentheses and will not affect the non-
primary server blade operation.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide