Hitachi Compute Blade 500 Series User Manual page 207

reconfigure authentication information. However, certificates and private
keys are automatically re-created when management modules start.
If you add or change authentication information after this command
finishes, the information is retained without being encrypted.
When the status of authentication encryption is not changed:
If the status of the specified authentication encryption is same as the
current status, a message indicating that authentication encryption is
already enabled or disabled appears.
Role
Chassis
Parameters
-e <encryption>
Enables or disables authentication encryption.
enable : Enabled.
disable : Disabled.
-F
Executes the command without inquiry.
Show items
None
Message
None
Example
[Enables authentication encryption]
A response message notifying the user that settings have been changed
appears before the management modules restart.
$ set user authentication encryption -e enable
W0006 : If confirm, management module restart and this connect
is lost.
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
• Make sure that you obtain backups before changing authentication
encryption.
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-189