Hitachi Compute Blade 500 Series User Manual page 61

Initializes EFI setting information on a specified server blade regardless of
whether the server blade is in SMP configuration or not.
Role
Server Blade
Parameters
<blade_no>
Slot number of server blade to the server chassis.
Range is from 0 to 7.
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted, the
command shows all server blades.
-F
Executes the command without inquiry.
Show items
None
Message
None
Example
[Initializes the setting of EFI on the server blade 0.]
$ init blade efi setting 0
Confirm? (y/[n]):y
I0048 : <Blade 0> Initializing was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
When you specify a non-primary server blade in SMP configuration, this
command is successfully completed. But the setting will not be applied to the
server blade.
When this command is executed to CB 520X B1/B2, BMC will automatically
start up. SEL for a communication error occurred between server blade SVP
and BMC, IPMI over LAN, may be collected, which has no problem.
When CB 520X B1/B2 or CB 520H B3/B4 is turned on, the following message
appears without executing this command.
<Blade X> Command was canceled. Response from BMC was abnormal.
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-43