Set User Authentication Encryption - Hitachi Compute Blade 500 Series User Manual

Message
None
Example
[Displays whether authentication encryption is enabled or disabled]
$ show user authentication encryption
-- Authentication encryption --
Authentication encryption : enable
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None

set user authentication encryption

Command
set user authentication encryption -e <encryption> [-F]
Description
Sets whether to encrypt authentication information.
If authentication encryption is enabled, the management modules encrypt
and retain authentication information.
If authentication encryption is disabled, the management modules retain
authentication information without encrypting it.
The behavior of the command differs, as follows, based on whether
authentication encryption is enabled or disabled:
When authentication encryption is enabled:
Authentication encryption is enabled.
Both the active and standby management modules restart.
After both of the above restart, authentication information that is already
set in the management modules is encrypted.
If you add or change authentication information after this command
finishes, the information is encrypted and retained (encryption method:
AES256-CBC).
When authentication encryption is disabled:
Authentication encryption is disabled.
Both the active and standby management modules restart.
After both of the above restart, authentication information that is already
set in the management modules is cleared. Because of this, you must
2-188
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide