Show Mac Original - Hitachi Compute Blade 500 Series User Manual

Example
[Displays MAC address which the card installed on server blade 0 is using. ]
$ show mac current -b 0
-- Current MAC List --
Slot
MAC type
Card
----------- --- ---------- ---- ------------------
mezzanine
mezzanine
mezzanine
mezzanine
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
When you specify -p parameter and a non-primary server blade in SMP
configuration, the following message appears without showing MAC address.
E0640 : <Blade %1$d> Command was canceled. Specified blade is not the
primary blade of SMP.

show mac original

Command
Show mac original [-b <blade_no>] [-p]
In SMP configuration
When you specify the primary server blade or a non-primary server blade,
MAC address of the specified server blade is displayed.
When specifying -p parameter, specify the primary server blade with -b
parameter to show MAC address of all server blades in SMP configuration.
Not in SMP configuration
Shows MAC address of the server blade specified with -b parameter. Even
if -p parameter is specified, the result is the same.
Description
Displays Default Physical MAC address which the card installed on server
blade is using.
Role
Chassis
2-16
: 0
: original
Num Controller Port MAC address
1
1
1
1
Command: show mac original -b <server blade number>
Command: show mac original -b <server blade number> -p
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
0 0 00:00:87:b8:65:90
0 1 00:00:87:b8:65:91
0 2 00:00:87:b8:65:92
0 3 00:00:87:b8:65:93