Show Remote-Access Protocol Ssh - Hitachi Compute Blade 500 Series User Manual

[To prohibit all HTTPS connections from IPv4 addresses, and to leave the
HTTPS connection permission settings for IPv6 addresses unchanged]
$ set remote-access protocol https -a deny
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To prohibit all HTTPS connections from all IPv4 and IPv6 addresses]
$ set remote-access protocol https -a deny -a6 deny
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None

show remote-access protocol ssh

Command
show remote-access protocol ssh
Description
Shows the setting of connection allowance of SSH.
This command is used to display the following items:
(1) Connection permission settings for IPv4 addresses
¢
¢
(2) Connection permission settings for IPv6 addresses
¢
¢
Role
Chassis
Parameters
None
Whether SSH connections are permitted
Range of IP addresses to be permitted (network address and subnet
mask)
Whether SSH connections are permitted
Range of IP addresses to be permitted (network address and prefix
length)
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-223