Hitachi Compute Blade 500 Series User Manual page 49

Each of the following indicates an initialization status of a single
server blade:
• Not install : The server blade is not installed.
• Not initialize : The server blade is not initialized.
• Init executing : The server blade is now being initialized.
• Init comp : The server blade was successfully initialized.
• Init comp NG : Initialization of the server blade failed.
• ----- : This indicates the larger slot number (an odd number) used
for the full-width blade.
Power detail
Power status of server blade.
Off : Server blade is powered off.
Reserve : Server blade is waiting delayed power on.
Powering on : Server blade is powering on.
On : Server blade is powered on.
Powering off : Server blade is powering off.
----- : This indicates that the server blade is not installed.
Alternatively, this indicates a non-primary server blade in an SMP
configuration or the larger slot number (an odd number) used for the
full-width blade.
In an SMP configuration, if you specify the primary server blade, the
detailed power supply status for the entire SMP configuration is
displayed.
Power
Status of power
Off : Server blade is powered off.
On : Server blade is powered on.
----- : This indicates that the server blade is not installed.
Alternatively, this indicates a non-primary server blade in an SMP
configuration or the larger slot number (an odd number) used for the
full-width blade.
In an SMP configuration, if you specify the primary server blade, the
power supply status for the entire SMP configuration.
Fail
Status of server blade failure.
Normal : Server blade is normal.
----- : This indicates that the server blade is not installed.
Alternatively, this indicates the larger slot number (an odd number)
used for the full-width blade.
An error state of each specified server blade is shown regardless of
whether the server blade is in SMP configuration or not.
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-31