Hitachi Compute Blade 500 Series User Manual page 303

- Lowest value for the upper limit of electric power consumption set by
the APC within the past three minutes
- Airflow
- Intake air temperature
For server blades
- Moving average value for electric power consumption (DC) for the past
three minute
- Upper limit of electric power consumption set by the APC
- Highest value for the upper limit of electric power consumption set by
the APC within the past three minutes
- Lowest value for the upper limit of electric power consumption set by
the APC within the past three minutes
- CPU frequency (average)
- CPU frequency (maximum)
- Highest value for electric power consumption (DC) within the past three
minutes
- Lowest value for electric power consumption (DC) within the past three
minutes
In SMP configuration, when you specify the primary server blade, power
values show total amount of power consumed by all server blades in SMP
configuration. CPU frequency value shows that on the primary server blade.
When you specify a non-primary server blade, power values show "-----" and
CPU frequency value shows that on the non-primary server blade.
Role
Chassis
Parameters
-m <log_power_module>
Select module to show power monitoring log.
chassis : Show chassis log.
blade : Show server blade log.
-b <blade_no>
Slot number of server blade in the server chassis.
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted, the
command shows all server blades.
-t <log_power_trend>
Select range of power monitoring logs to show.
last : Show logs of the last 24 hours.
yesterday : Show logs of 24 hours of the previous day.
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-285