Exit - Hitachi Compute Blade 500 Series User Manual

command. This command does not allow connection regardless of the
management module security level.
For connecting to a switch module management interface, use the
following commands.
¢
¢
For setting a management module security level, use the following
commands
¢
¢
When you specify a non-primary server blade in SMP configuration, the
following message appears without connecting to the OS console.
E0640 : <Blade %1$d> Command was canceled. Specified blade is not the
primary blade of SMP.
The user who denies permission to execute remote consoles and OS consoles
cannot connect the OS console for server blades.

exit

Command
exit
Description
Exit CLI console.
Role
All
Parameters
None
Show items
None
Message
None
Example
[Exit CLI console.]
Viewing: show sw-module mgmt-lan on page 2-96
Setting: set sw-module mgmt-lan on page 2-97
Viewing: show security setting on page 2-322
Setting: set security strength on page 2-325
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-317