Hitachi Compute Blade 500 Series User Manual page 101

If you entered -st enable, this item is required. If you entered -st
disable or omitted -st, omit this parameter.
-gs <dgw_setting>
Specify whether to enable use of the default gateway (IPv6).
enable: Enabled.
¢
disable: Disabled.
¢
If you entered -st enable, this item is required. If you entered -st
disable or omitted -st, omit this parameter.
If you want to specify the default gateway (-g), specify enable.
-g <default_gateway>
Default gateway (IPv6)
If you entered -st enable or -gs enable, this item is required.
If you entered -st disable or -gs disable, or if you omitted -st or -
gs, omit this parameter.
-F
Specify this parameter to execute the command without displaying a
confirmation dialog box. You can omit this parameter.
Show items
None
Message
None
Example
[To configure a static address for the management LAN settings (IPv6) for
Server Blade 0 and to enable use of the default gateway (In this case, the
address is specified by using -gs enable or -g.)]
$ set blade mgmt-v6 address 0 -st enable -i
fe80::200:87ff:feb2:c24 -p 64 -gs enable -g
fe80::200:87ff:feb2:c20
Confirm? (y/[n]):y
I0037 : <Blade 0> Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To configure a static address for the management LAN settings (IPv6) for
Server Blade 1 and to disable use of the default gateway (In this case, the
address is specified by using -gs disable.)]
$ set blade mgmt-v6 address 1 -st enable -i
fe80::200:87ff:feb2:c24 -p 64 -gs disable
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-83