Set Remote-Access Protocol Https - Hitachi Compute Blade 500 Series User Manual

Message
None
Example
[To display the port number for HTTPS connections and the connection
permission settings for IPv4 and IPv6 addresses]
$ show remote-access protocol https
-- HTTPS setting --
Port number
Allow
Network address
Subnet mask
-- HTTPS setting (IPv6) --
Allow
Network address
Prefix len
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None

set remote-access protocol https

Command
set remote-access protocol https [-a <allow>] [-p
<protocol_port>] [-n <network_addr>] [-s <subnet_mask>] [-a6
<allow>] [-n6 <network_addr>] [-p6 <prefix_len>] [-F]
Description
Edits the setting of connection allowance of https.
You can change the following items:
(1) Port number for HTTPS connections
(2) Connection permission settings for IPv4 addresses
¢
¢
(3) Connection permission settings for IPv6 addresses
2-220
If you do not want to limit the addresses from which connections are
permitted, specify "0".
: 443
: allow
: 192.168.0.0
: 255.255.255.0
: allow
: fe80::200:87ff:feb2:c24
: 64
Whether HTTPS connections are permitted
Range of IP addresses to be permitted (network address and subnet
mask)
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide