Hitachi Compute Blade 500 Series User Manual page 250

Show items
None
Message
None
Example
[To permit TELNET connections from IPv4 addresses between 192.168.0.0
and 192.168.0.255, and to leave the TELNET connection permission settings
for IPv6 addresses unchanged]
$ set remote-access protocol telnet -a allow -n 192.168.0.0 -s
255.255.255.0
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To permit TELNET connections from IPv6 addresses between fe80:: and
fe80::ffff:ffff:ffff:ffff, and to leave the TELNET connection permission settings
for IPv4 addresses unchanged]
$ set remote-access protocol telnet -a6 allow -n6 fe80:: -p6
64 -F
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To prohibit all TELNET connections from IPv4 addresses, and to leave the
TELNET connection permission settings for IPv6 addresses unchanged]
$ set remote-access protocol telnet -a deny
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To prohibit all TELNET connections from all IPv4 and IPv6 addresses]
$ set remote-access protocol telnet -a deny -a6 deny
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
2-232
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide