Show Blade Status - Hitachi Compute Blade 500 Series User Manual

Slot : 2
-- Blade AC recovery setting --
AC recovery : stay
Wait time(min) : 10
-- Blade pre-configure setting --
N+M : enable
WWN type : additional
MAC type : additional
-- OS mode --
OS mode : basic
S0002 : Command succeeded.
S0000 : Command was finished.
$
[Shows the non-primary server blade setting in SMP configuration.]
$ show blade setting 0
-- Blade setting --
Slot : 0
-- Blade AC recovery setting --
AC recovery : (stay)
Wait time(min) : (10)
-- Blade pre-configure setting --
N+M : (enable)
WWN type : (additional)
MAC type : (additional)
-- OS mode --
OS mode : (basic)
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None

show blade status

Command
show blade status [<blade_no>]
Description
The following table shows the status of server blade.
2-28
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide