Hitachi Compute Blade 500 Series User Manual page 86

Role
Server Blade
Parameters
<blade_no>
Slot number of server blade in the server chassis
-n <n+m>
Ability of N+M cold standby.
-w <wwn_type>
Type of WWN
-m <mac_type>
Type of MAC address
-F
Executes the command without inquiry.
Show items
None
Message
None
Example
[Enables N+M cold standby, sets the type of WWN to "additional", and then
sets the type of MAC address to "additional" for server blade 0]
$ set blade preconf 0 -n enable -w additional -m additional -F
I0037 : <Blade 0> Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
2-68
Range is from 0 to 7.
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted, the
command shows all server blades.
enable : N+M cold standby is enabled.
disable : N+M cold standby is disabled.
default : Default Physical WWN
optional : Optional Physical WWN
default : Default Physical MAC
optional : Optional Physical MAC
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide