Set Remote-Access Protocol Telnet - Hitachi Compute Blade 500 Series User Manual

Allow
Network address
Subnet mask
-- TELNET setting (IPv6) --
Allow
Network address
Prefix len
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None

set remote-access protocol telnet

Command
set remote-access protocol telnet [-a <allow>] [-n
<network_addr>] [-s <subnet_mask>] [-a6 <allow>] [-n6
<network_addr>] [-p6 <prefix_len>] [-F]
Description
Edits the setting of connection allowance of TELNET.
You can change the following items:
(1) Connection permission settings for IPv4 addresses
¢
¢
(2) Connection permission settings for IPv6 addresses
¢
¢
If you omit a parameter, the corresponding settings will not be changed. If
you omit all parameters, the command will end normally without making any
changes.
Role
Chassis
Parameters
-a <allow>
2-230
: allow
: 192.168.0.0
: 255.255.255.0
: allow
: fe80::200:87ff:feb2:c24
: 64
Whether TELNET connections are permitted
Range of IP addresses to be permitted (network address and subnet
mask)
Whether TELNET connections are permitted
Range of IP addresses to be permitted (network address and prefix
length)
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide