Show Blade Bmc Session - Hitachi Compute Blade 500 Series User Manual

Example
[Edits the local time of BMC on server blade 0.]
$ set blade bmc time local 0 -d "2012-05-01 15:00:00" -F
I0037 : <Blade 0> Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
• This command cannot be used to change the BMC time if the BMC time
adjustment method for the server blade is set to Synchronize time to
the management module using NTP.
If Synchronize time to the management module using NTP is
specified and this command is executed, the BMC time is not changed.
However, the following message indicating that the command finished
normally is displayed:
I0037 : <Blade X> Setting was completed. (X: Server blade number)
• This command cannot change the BMC time for the CB520X B1/B2.
Executing this command does not change the BMC time. However, the
following message indicating that the command finished normally is
displayed:
I0037 : <Blade X> Setting was completed. (X: Server blade number)

show blade bmc session

Command
show blade bmc session [<blade_no>]
Description
Shows the following session items of the Remote Console connected to a
server blade.
• Session number
• Session kind
• Session ID
• IP kind
• IP address of the source
• User name
• Session start time
In SMP configuration, specify the primary server blade to show information of
the remote console session on the primary server blade.
2-38
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide