Hitachi Compute Blade 500 Series User Manual page 154

Show items
None
Message
None
Example
[To configure a static address for the management LAN settings (IPv6) for
the management module and to enable use of the default gateway (In this
case, the address is specified by using -gs enable or -g.)]
$ set mgmt-module mgmt-v6 address -st enable -i
fe80::200:87ff:feb2:c24 -p 64 -gs enable -g
fe80::200:87ff:feb2:c20
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To configure a static address for the management LAN settings (IPv6) for
the management module and to disable use of the default gateway (In this
case, the address is specified by using -gs disable.)]
$ set mgmt-module mgmt-v6 address -st enable -i
fe80::200:87ff:feb2:c24 -p 64 -gs disable
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To disable the static address for the management LAN setting (IPv6) for the
management module]
$ set mgmt-module mgmt-v6 address -st disable
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
Checking the specified address
The static address and the IPv6 address for the default gateway are
configured only if they are determined to be valid based on the format
check. (For more information about the format check, see
and Display the IP Address on page
2-136
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-4.)
How to Specify