Set Power Capping - Hitachi Compute Blade 500 Series User Manual

Comment
None

set power capping

Command
set power capping -b <blade_no> [-e <blade_power_epc_mask>] [-a
<blade_power_apc_mask>] [-F]
Description
Edits the following power capping settings for a server blade.
• Emergency power control (EPC)
• Accurate power control (APC)
When you specify the primary server blade, power capping settings for all
server blades are edited. When you specify a non-primary server blade, the
setting value is edited but will not affect the non-primary server blade
operation.
Role
Chassis restriction
Parameters
-b <blade_no>
Slot number of server blade in the server chassis.
-e <blade_power_epc_mask>
Power capping mask (EPC)
-a <blade_power_apc_mask>
Power capping mask (APC)
-F
Executes the command without inquiry.
Range is from 0 to 7.
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted, the
command shows all server blades.
enable : Not limit the power consumption by EPC
disable : Limit the power consumption by EPC
enable : Not limit the power consumption by APC
disable : Limit the power consumption by APC
This parameter cannot be specified in DCMI mode.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-199