Hitachi Compute Blade 500 Series User Manual page 153

• IP address (IPv6)
• Prefix length
• Whether to enable use of the default gateway
• Default gateway
Role
Network privilege
Parameters
-st <setting>
Specify whether to enable use of a static address.
enable: Enabled.
¢
disable: Disabled.
¢
You cannot omit this parameter.
-i <ip_address>
IP address (IPv6)
If you entered -st enable, this item is required. If you entered -st
disable or omitted -st, omit this parameter.
-p <prefix_len>
Prefix length
Specify a value from 1 to 128.
If you entered -st enable, this item is required. If you entered -st
disable or omitted -st, omit this parameter.
-gs <dgw_setting>
Specify whether to enable use of the default gateway (IPv6).
enable: Enabled.
¢
disable: Disabled.
¢
If you entered -st enable, this item is required. If you entered -st
disable or omitted -st, omit this parameter.
If you want to specify the default gateway (-g), specify enable.
-g <default_gateway>
Default gateway (IPv6)
If you entered -st enable or -gs enable, this item is required.
If you entered -st disable or -gs disable, or if you omitted -st or -
gs, omit this parameter.
-F
Specify this parameter to execute the command without displaying a
confirmation dialog box. You can omit this parameter.
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-135