Poweroff Blade - Hitachi Compute Blade 500 Series User Manual

The server blade will not power on when the OS is in LP mode and LP license
is not set.
When you specify a non-primary server blade in SMP configuration, the
following message appears without powering on the server blade.
E0640 : <Blade %1$d> Command was canceled. Specified blade is not the
primary blade of SMP

poweroff blade

Command
poweroff blade [<blade_no>] [-h|-s] [-F]
Description
Powers off the server blade using the following two methods.
• Forcible power-off
• Shutdown to power off
You can select one of methods above by specifying a parameter, -h or -s.
• Forcible power-off
Specify -h to turn off the power forcibly.
• Shutdown to power off
Specify -s to shut down the OS running on the selected server blade,
which turns the power off. The power may not be turned off depending on
settings for the OS on the server blade. Check the OS settings before
using this parameter.
When neither -h nor -s is specified, the power will be turned off in the same
way as -s is specified.
In SMP configuration, specify the primary server blade to power off all server
blades in the configuration.
Role
Server Blade
Parameters
<blade_no>
Slot number of the server blade in the server chassis
-h
Range is from 0 to 7.
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted, the
command shows all server blades.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-53