YASKAWA UAK series User Manual page 138

2.
Mount the cable connector on the servomotor and fix it with screws as shown in the figure
below.
U
V
W
G
∗
In this case, contact your Yaskawa representative.
• First, connect the servomotor to the servomotor main circuit cable end.
• Do not remove the O-ring. Mount the connector so that the O-ring is seated properly.
If the O-ring is not seated properly, the requirements for the protective structure
specifications may not be met.
Encoder cable
All models
O-ring
Servomotor main circuit cable
SGMGV-05
4-M3 pan-head screws
Tightening torque: 0.44 N m
Lead on Non-load Side
Lead on Load Side*
7.1 Motors
7
7-13