Rx Gearbox; Functional Description; Ports And Attributes - Xilinx Virtex-6 FPGA User Manual

Chapter 4: Receiver

RX Gearbox

Functional Description

The RX gearbox uses output pins RXDATA[31:0] and RXHEADER[2:0] for receiving data.
Similar to
clock. Because of this, occasionally, the output data is invalid. Output pins
RXHEADERVALID and RXDATAVALID determine if the appropriate header and data are
valid. The RX gearbox only supports 2-byte and 4-byte interfaces. A 1-byte interface is not
supported.
The data out of the RX gearbox is not necessarily aligned. Alignment is done in the FPGA
logic. The RXGEARBOXSLIP port can be used to slip the data from the gearbox cycle-by-
cycle until the correct alignment is reached. It takes a specified amount of cycles before the
bitslip operation is processed and the output data is stable.
Descrambling of the data and block synchronization is done in the FPGA logic.

Ports and Attributes

Table 4-50
Table 4-50: RX Gearbox Ports
Port Dir
RXDATAVALID Out
RXGEARBOXSLIP In
RXHEADER[2:0] Out
RXHEADERVALID Out
RXSTARTOFSEQ Out
Table 4-51
Table 4-51: RX Gearbox Attributes
www.BDTIC.com/XILINX
256
TX Gearbox, page
defines the RX gearbox ports.
Clock Domain
RXUSRCLK2 Status output when Gearbox 64/66 or 64/67 is used, which indicates that
the data appearing on RXDATA is valid. For example, during 64B/66B
encoding, this signal is deasserted every 32 cycles for the 4-byte interface
and every 64 cycles for the 2-byte interface.
RXUSRCLK2 When High, this port causes the gearbox contents to slip by one bit. It is
used to achieve alignment with the FPGA logic. Asserting this port for
one RXUSRCLK2 cycle changes the data alignment coming out of the
gearbox.
When RXGEARBOXSLIP is asserted for more than one cycle, the gearbox
realigns the data once for each RXUSRCLK2 cycle that it is held High.
RXUSRCLK2 Header outputs for 64/66 (1:0) and 64/67 (2:0).
RXUSRCLK2 Indicates that the RXHEADER is valid when using the gearbox.
RXUSRCLK2 When Gearbox 64/66 or 64/67 is enabled, this output indicates when the
sequence counter is 0 for the present RXDATA outputs.
defines the RX gearbox attributes.
Attribute
GEARBOX_ENDEC 3-bit Binary
RXGEARBOX_USE Boolean
www.xilinx.com
146, the RX gearbox operates with the PMA using a single
Description
Type
Gearbox Modes:
000: 64B/67B using external sequence counter
001: 64B/66B using external sequence counter
010: 64B/67B using internal sequence counter
011: 64B/66B using internal sequence counter
When TRUE, this attribute enables the RX gearbox.
Virtex-6 FPGA GTX Transceivers User Guide
Description
UG366 (v2.5) January 17, 2011