Siemens SIMOVERT MASTERDRIVES Manual page 1172

Parameter Description
P361* Backlight for the optional operation panel OP
OP Backlight Parameter values:
0 = Backlight always ON
361 1 = Backlight only ON during operation
P363* Function parameter for starting the "Copy BICO Data Set"
Copy BICO DSet function. With this function, the settings of one BICO data
set (Index 1 or 2) are transferred to the other data set.
363 Starting takes place with a parameter setting not equal to
0. The last two digits of the parameter value indicate
which source data set (penultimate digit) is to be copied to
which target data set (last digit). After the function has
been performed, the parameter is automatically reset to 0.
0 = No activity
12 = Copies Index 1 of the BDS parameters to Index 2
21 = Copies Index 2 of the BDS parameters to Index 1
P364* Function call for "Copy Function Data Set". The last two
Copy FuncDSet digits of the parameter value indicate which source data
set (penultimate digit, value range 1 to 4) is to be copied
364 to which target data set (last digit, value range 1 to 4).
After the function has been performed, the parameter is
automatically reset to "0".
Function parameter for starting the "Copy Function Data
Set" function. With this function, the settings of a function
data set (Index 1, 2, 3 or 4) are transferred to another
data set. Starting takes places with a parameter setting
not equal to 0. The last two digits of the parameter value
indicate which source data set (penultimate digit) is to be
copied to which target data set (last digit). After the
function has been performed, the parameter is
automatically reset to 0.
Examples
0 = No activity
12 = Copies Index 1 of the FDS parameters to Index 2
31 = Copies Index 3 of the FDS parameters to Index 1
24 = Copies Index 2 of the FDS parameters to Index 4
P366* Reserved for future use
Select FactSet
366
P367* Function parameter for selecting a control configuration
Select Reg Type which is to be parameterized when a quick
parameterization (P370) is carried out.
367
0 = V/f control
1 = - not used -
2 = Torque control
3 = Speed control
Siemens AG 6SE7087-6QX70 (Edition AG)
SIMOVERT MASTERDRIVES Compendium Motion Control
Data Read/write
Init: 1 Menus:
Min: 0 - Parameter menu
Max: 1 + Functions
Unit: - - Upread/free access
Indices: - Changeable in:
Type: O2 - Ready to switch on
- Operation enabled
Init: 0 Menus:
Unit: - - Parameter menu
Indices: - + Functions
Type: L2 - Upread/free access
Changeable in:
- Ready to switch on
Init: 0 Menus:
Unit: - - Parameter menu
Indices: - + Functions
Type: L2 - Upread/free access
Changeable in:
- Ready to switch on
Init: 0 Menus:
Min: 0 - Parameter menu
Max: 10 - Upread/free access
Unit: - Changeable in:
Indices: - - Ready to switch on
Type: O2
Init: 0 Menus:
Min: 0 - Parameter menu
Max: 3 - Quick parameterization
Unit: - - Upread/free access
Indices: - Changeable in:
Type: O2 - Ready to switch on
55