Figure 123: Removing The Sib From A Qfx10016 Chassis - Juniper QFX10016 Hardware Manual

Hide thumbs Also See for QFX10016:

Table of Contents

QFX10016 Switch Hardware Guide

Figure 123: Removing the SIB from a QFX10016 Chassis

Support the SIB as you rotate the SIB 90 degrees and place it on the antistatic mat

with the printed circuit (PC) board facing upward. Be careful not to bump or handle

the SIB by the connectors. If you do not have an antistatic mat, have another person

help you slide the electrostatic bag over the SIB before placing it on the stable surface.

Figure 124 on page

Do not stack hardware components on top of one another after

you remove them. Place each component on an antistatic mat resting on

a stable, flat surface.