Juniper QFX10016 Hardware Manual page 196

QFX10016 Switch Hardware Guide
172
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
(Optional) Configure the name of the switch. If the name includes spaces, enclose
6.
the name in quotation marks (" ").
[edit]
root@# set system host-name host-name
Configure the default gateway.
7.
[edit]
root@# set routing-options static route default next-hop address
Configure the IP address and prefix length for the switch management interface.
8.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION: Although the CLI permits you to configure two management
Ethernet interfaces within the same subnet, only one interface is usable
and supported.
NOTE: The management ports,
(also labeled
em1
panel of the QFX10002 and on each of the Control Boards of the
QFX10008 and QFX10016.
(Optional) Configure the static routes to remote prefixes with access to the
9.
management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
Enable Telnet service.
10.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a QFX10000 through
Telnet using root credentials. Root login is allowed only for SSH access.
Commit the configuration to activate it on the switch.
11.
(
em0 MGMT
for fiber connections), are found on the port
MGMT
Copyright © 2017, Juniper Networks, Inc.
for RJ-45 connections) and