Unpacking And Mounting The Switch; Qfx10016 Installation Overview - Juniper QFX10016 Hardware Manual

CHAPTER 12

Unpacking and Mounting the Switch

QFX10016 Installation Overview

Copyright © 2017, Juniper Networks, Inc.
QFX10016 Installation Overview on page 141
Unpacking the QFX10016 on page 142
Unpacking QFX10000 Line Cards, Control Boards, and Switch Interface
Boards on page 145
Comparing the QFX10000 Order to the Packing List on page 146
Installing the Mounting Hardware for a QFX10000 on page 150
Mounting a QFX10016 in a Four-Post Rack Using a Mechanical Lift on page 153
Installing the Front Panel on a QFX10000 on page 156
The QFX10016 is a rigid sheet-metal switch-chassis that houses the other hardware
components such as Control Boards, Switch Interface Boards (SIBs), power supplies,
fan trays, and line cards. The switch chassis ships in a cardbox box that has a two-layer
wooden pallet base. The switch chassis is bolted to the pallet base. You can install a
QFX10016 switch in a standard 19 in. (483 mm) equipment rack by using the supplied
rack-mounting kit and the front-mounting bracket that is attached to the chassis.
The steps to install the QFX10016 are:
Unpack the switch following the instructions in
1.
Mount the chassis in the rack following the instructions in
2.
a Four-Post Rack Using a Mechanical Lift" on page
WARNING: Because of the weight of the chassis, manual mounting is not
recommended.
Install the line cards following the instructions in
3.
on page 229.
Connect the chassis to earth ground following the instructions in
4.
Ground to a QFX10000" on page
"Unpacking the QFX10016" on page
"Mounting a QFX10016 in
153.
"Installing a QFX10000 Line Card"
162.
142.
"Connecting Earth
141