Qfx10000 Management Port Leds; Figure 21: Management Port Leds On A Qfx10000 - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
Table 9: Control Board Status LEDs (continued)
LED
STS
MST

QFX10000 Management Port LEDs

30
Color State
Green On steadily
Green Blinking
Yellow On steadily
Yellow Blinking
Dark Unlit
Green On steadily
Dark Unlit
There are two management ports on the Control Board of a QFX10008 and QFX10016
that have LEDs that indicate link status and link activity. These two ports, located on the
Control Board panel between the clocking connections and the USB port, are both labeled
. The left management port is an SFP cage that can accommodate up to 1G copper
MGMT
or fiber connections (see Figure 21 on page
LEDs for status and activity. The fiber (SFP) port has a combination link and activity LED.

Figure 21: Management Port LEDs on a QFX10000

1— Status LED (RJ-45)
2—Activity LED (RJ-45)
Table 10 on page 31 describes the RJ-45 management port LEDs, and
describes the SFP status LEDs.
Description
The Control Board is online and functioning correctly.
The beacon feature is enabled.
The Control Board is booting.
The Control Board has detected an error.
The power supply is switched off.
The Control Board is the master.
The Control Board is the backup.
30). The copper (RJ-45) port has separate
3— Green indicates the link is up; blinking
indicates activity (SFP)
Copyright © 2017, Juniper Networks, Inc.
Table 11 on page 31