Figure 79: Esd Point On Qfx10008 Chassis Rear; Figure 80: Esd Point On Qfx10016 Chassis Rear - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
182
To remove a QFX10000 fan tray (see
Figure 82 on page 184 for the QFX10016):
Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the ESD point on the rear left side of the chassis. See
Figure 79 on page 182 and

Figure 79: ESD Point on QFX10008 Chassis Rear

Figure 80: ESD Point on QFX10016 Chassis Rear

1— ESD point
Loosen the four captive screws either by unscrewing with your thumb and forefinger
2.
or with a Phillips screwdriver.
Grasp the top and bottom handles and pull the fan tray out about 3 in. (7.6 cm). See
3.
Figure 81 on page 183 for the QFX10008 and
Figure 81 on page 183
Figure 80 on page 182.
Figure 82 on page 184
Copyright © 2017, Juniper Networks, Inc.
for the QFX10008 and
for the QFX10016.