Figure 58: Mounting Brackets For Four-Post Rack Installation - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
Related
Documentation
152
Hand-tighten the screws fully (to 12–16 in.-lb torque) using a number 2 Phillips
b.
screwdriver.

Figure 58: Mounting Brackets for Four-Post Rack Installation

1— Front adjustable mounting brackets
Position the right front adjustable mounting bracket at the desired position in the right
6.
side of the rack opposite the installed left front bracket, so that it is on the same rack
level as the left bracket. If the right and left front brackets are not on the same level,
the chassis will rest at an angle in the rack instead of resting flat and level. Line up the
right bracket's front screw holes with the holes in the rack. Use four mounting screws
appropriate for your rack to attach the right front bracket to the rack.
Position the other rear bracket at the right rear of the rack on the same level as the
7.
right front bracket, so that the rear bracket overlaps with the right front bracket. The
screw holes for connecting the front and rear brackets should overlap. Use four
mounting screws appropriate for your rack to attach the rear bracket to the rack.
Connect the right front and rear brackets (see
8.
Insert six of the screws provided with the mounting brackets into the overlapping
a.
bracket holes.
Hand-tighten the screws fully (to 12–16 in.-lb torque) using a number 2 Phillips
b.
screwdriver.
Mounting a QFX10016 in a Four-Post Rack Using a Mechanical Lift on page 153
2— Rear adjustable mounting brackets
Figure 58 on page 152):
Copyright © 2017, Juniper Networks, Inc.