Juniper QFX10016 Hardware Manual page 316

QFX10016 Switch Hardware Guide
292
Table 66: Chassis Component Alarm Conditions on QFX10000 Modular
Models (continued)
Chassis
Component Alarm Condition
Hot Too many hot-swap
interrupts are occurring.
swapping
Power A power supply has been
removed from the
supplies
chassis.
A power supply has a high
temperature.
A power supply input has
failed.
A power supply output
has failed.
A power supply has
failed.
AC and DC power
supplies are installed.
Inadequate number of
power supplies.
Alarm
Severity Remedy
Major Replace the failed components.
(red)
Minor Install a power supply in the empty
(yellow) slot.
Major Replace the failed power supply.
(red)
Major Check power supply input connection
(red) and the power cord.
Major Check power supply output
(red) connection.
Major Replace the failed power supply.
(red)
Major Do not mix AC and DC power
(red) supplies.
Major Install an additional power supply.
(red)
Copyright © 2017, Juniper Networks, Inc.