Table 18: Leds On An Dc Power Supply In Qfx10000 - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide

Table 18: LEDs on an DC Power Supply in QFX10000

LED
or
INP1 INP2
PWR OK
FAULT
Related
Documentation
50
Table 18 on page 50 describes the LEDs in QFX10008 and QFX10016 modular chassis.
Color State
Yellow Blinking
Green Solid
Unlit Off
Green Solid
Yellow Blinking
Red Solid
Unlit Off
NOTE: If the
INP1
not installed properly or the power supply has failed.
If the or
INP1 INP2
supply is not installed properly or the power supply has an internal failure.
If the FAULT LED is blinking, add a power supply to balance the power demand
and supply.
QFX10000 DC Power Specifications on page 123
Power Requirements for QFX10000 Components on page 113
Connecting DC Power to a QFX10000 on page 165
Description
Indicates one of the following:
DC power input voltage is not within normal operating
range.
DC power is within operating range (-40 VDC to -72
VDC).
The power supply is switched off.
DC power output is within normal operating range.
The output is out of the limits.
Power supply has failed and must be replaced.
Power supply is functioning normally. Or, only one input
is powered and the enable switch for the input that is
not powered is set to
to a QFX10000" on page 165
the enable switches.
or and the LED are unlit, the power cords are
INP2 PWR OK
LED is lit green and the
PWR OK
. See "Connecting DC Power
ON
for more information on
LED is unlit, the power
Copyright © 2017, Juniper Networks, Inc.