Figure 98: Removing An Ac Power Supply From A Qfx10008 - Juniper QFX10016 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Turn the adjustment nut of the power cord retainers counterclockwise till you can see
5.
the power cord. Pull the power cord from the slot in the adjustment nuts.
Unscrew the captive screw counterclockwise by using the Phillips (+) screwdriver,
6.
number 1. See Figure 98 on page 197
Rotate the captive screw away from the faceplate of the power supply to release the
7.
latch.
Taking care not to touch the power supply output connections, pins, leads, or solder
8.
connections, place one hand under the power supply to support it. Grasp the power
supply handle with your other hand and pull the power supply completely out of the
chassis.
CAUTION: Do not bump the output connections. If the connection hits a
solid object, it could damage the power supply.
If you are not replacing the power supply, install the cover panel over the slot by
9.
inserting your thumb and forefinger into the finger holes, squeezing and pulling the
cover out of the slot.

Figure 98: Removing an AC Power Supply from a QFX10008

Chapter 17: Replacing Power Supplies
and Figure 99 on page 198.
197