Copyright © 2017, Juniper Networks, Inc.
Figure 103: Connecting the DC Power Supply Cables to a QFX10000
Install the plastic cable cover over each set of power cables by using the
11.
Phillips (+) screwdriver, number 2, to tighten the screw.
If the power supply slot on the chassis has a cover panel on it, insert your thumb and
12.
forefinger into the finger holes, squeeze, and pull the cover out of the slot. Save the
cover panel for later use (see
Figure 105 on page 204
Figure 104 on page 204
for QFX10016 installations).
Chapter 17: Replacing Power Supplies
for QFX10008 installations and
203