Figure 110: Removing A Dc Power Supply From A Qfx10008 - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
210
Rotate the captive screw away from the faceplate of the power supply to release the
5.
latch. See Figure 110 on page 210
Taking care not to touch power supply components, pins, leads, or solder connections,
6.
place one hand under the power supply to support it. Grasp the power supply handle
with your other hand and pull the power supply completely out of the chassis.
If you are not replacing the power supply, install the cover panel over the slot.
7.
Insert your thumb and forefinger into the finger holes of the cover panel.
a.
Squeeze and place the cover in the slot.
b.
Release your fingers and the cover remains in the slot.
c.
Unscrew the screw on the plastic cable cover that shield the input terminal studs
8.
counterclockwise by using the Phillips (+) screwdriver, number 2.
Unscrew the nuts counterclockwise using the 13/32 in. (10 mm) nut driver or socket
9.
wrench from the input terminal studs.
Remove the cable lugs from the input terminal studs.
10.

Figure 110: Removing a DC Power Supply from a QFX10008

and Figure 111 on page 211.
Copyright © 2017, Juniper Networks, Inc.