Qfx10000 Power Cord Specifications - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
Related
Documentation

QFX10000 Power Cord Specifications

120
QFX10000 AC Power Supply on page 43
QFX10000 AC Power Supply LEDs on page 48
QFX10000 Power Cord Specifications on page 120
Each AC power supply has a single AC appliance inlet that requires a dedicated AC power
feed. Most sites distribute power through a main conduit that leads to frame-mounted
power distribution panels, one of which can be located at the top of the rack that houses
the switch. An AC power cord connects each power supply to the power distribution
panel.
Each detachable AC power cord is 8 feet (approximately 2.5 meters) long. The appliance
coupler at the female end of the cord inserts into the AC appliance inlet on the faceplate
of the AC power supply. The coupler type is C19 as described by the International
Electrotechnical Commission (IEC) standard 60320. The plug at the male end of the
power cord fits into the power source outlet that is standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 15 feet
(approximately 4.5 meters) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical
Code (CEC) Section 4-010(3). The cords shipped with the switch to North
America and Canada are in compliance.
Table 51 on page 121 lists the AC power cord specifications for QFX10000 modular
switches for various countries and regions.
Copyright © 2017, Juniper Networks, Inc.