Juniper QFX10016 Hardware Manual page 232

QFX10016 Switch Hardware Guide
208
CAUTION: Before you remove a power supply, ensure that you have power
supplies sufficient to power the switch left in the chassis. See
Requirements for QFX10000 Components" on page
Before you remove a DC power supply from the switch:
Ensure you understand how to prevent ESD damage. See
Discharge Damage" on page
Ensure that you have the following parts and tools available to remove a DC power supply:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, numbers 1 and 2
13/32 in. (10 mm) nut driver or socket wrench
Replacement power supply or a cover panel for the power supply slot
CAUTION: Do not leave the power supply slot empty for a long time while
the switch is operational. Either replace the power supply promptly or install
a cover panel over the empty slot.
To remove a DC power supply from a QFX10000 switch (see
327.
Copyright © 2017, Juniper Networks, Inc.
"Power
113.
"Prevention of Electrostatic
Figure 110 on page 210):