Figure 96: Esd Point On Qfx10008 Chassis Rear; Figure 97: Esd Point On Qfx10016 Chassis Rear - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
196
Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the ESD point on the chassis. There is an ESD point located next
to the protective earthing terminal and below
Figure 96 on page 196) and below

Figure 96: ESD Point on QFX10008 Chassis Rear

1— ESD point

Figure 97: ESD Point on QFX10016 Chassis Rear

1— ESD point
Flip the switch next to the appliance inlet on the power supply to the standby
2. Enable
position.
Disconnect power from the switch by performing one of the two following tasks:
3.
If the AC power source outlets have a power switch, set them to the OFF position.
If the AC power source outlets do not have a power switch, gently pull the male end
of the power cords connected to the power source outlets out of the outlets.
Remove the power cords from the AC appliance inlets on the AC power supply
4.
faceplate.
on the QFX10008 rear panel (see
PSU 5
on the QFX10016 (see
PSU_9
Copyright © 2017, Juniper Networks, Inc.
Figure 97 on page 196).