Qfx10000 Dc Power Supply Leds; Figure 30: Leds On A Dc Power Supply In Qfx10000 Switches - Juniper QFX10016 Hardware Manual

Table 17: LEDs on an AC Power Supply in QFX10000 (continued)
LED
FAULT
Related
Documentation

QFX10000 DC Power Supply LEDs

Copyright © 2017, Juniper Networks, Inc.
Color State
Dark Unlit
Red Solid
NOTE: If the INP1
cord is not installed properly or the power supply has failed.
If the or
INP1 INP2
is not installed properly or the power supply has an internal failure.
QFX10000 AC Power Specifications on page 119
Power Requirements for QFX10000 Components on page 113
QFX10000 Power Cord Specifications on page 120
Connecting AC Power to a QFX10000 on page 165
A DC power supply has four LEDs on its faceplate:
LEDs display information about the status of the power supply. See

Figure 30: LEDs on a DC Power Supply in QFX10000 Switches

1— INP1–Source input 1
2— INP2–Source input 2
Chapter 5: Power System Components and Descriptions
Description
Power supply is functioning normally.
Power supply has failed and must be replaced. Or, only
one input is powered and the enable switch for the
input that is not powered is set to
a QFX10000 AC Power Supply" on page 189
information about the enable switches.
or INP2 LED and the PWR OK
LED is lit and the
PWR OK
,
INP1
3— PWR OK
4— FAULT
ON . See "Installing
for more
LED are unlit, the AC power
LED is unlit, the AC power supply
, , and . These
INP1 PWR OK FAULT
Figure 30 on page 49.
49