Connecting A Fiber-Optic Cable - Juniper QFX10016 Hardware Manual

Related
Documentation

Connecting a Fiber-Optic Cable

Copyright © 2017, Juniper Networks, Inc.
WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
Cover the fiber-optic cable connector with the rubber safety cap.
4.
Connecting a Fiber-Optic Cable on page 257
Removing a Transceiver on page 251
Maintaining Fiber-Optic Cables on page 258
Before you begin connecting a fiber-optic cable to an optical transceiver installed in a
device, ensure that you have taken the necessary precautions for safe handling of lasers
(see Laser and LED Safety Guidelines and Warnings).
To connect a fiber-optic cable to an optical transceiver installed in a device:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the optical transceiver. Save the cap.
2.
Insert the cable connector into the optical transceiver (see
3.
Chapter 22: Replacing Transceivers and Fiber-Optic Cables
Figure 155 on page 258).
257